LET'S TALK ABOUT…
your project!
Take advantage of the innovative connected navigation…
Dreevo Lite
Add navigation and messaging to the C4!
The SDP5 and the complete line of smart display are Mobile Data Terminal designed to add Navigation and Messaging capabilities to the C4.
Pre installed
Navigation & Messaging application
Plug & play
we take care of every connection issue
Advanced
mounting system
The C4 is also fully programmable through our powerful SDK which let you modify all its features according to your specific needs.
HARDWARE FEATURES OF THE SDP5
Display Type Resolution Size and ratio |
TFT |
Touch panel |
Resistive |
Communication interface RS232 (RX/TX only) |
1 (to connect to C4) |
Embedded loudspeaker |
1 |
Main controller |
Intel PXA 270 (312 MHz) |
RAM |
128 MB |
Flash memory |
512 MB |
Real-time clock |
1 |
Light sensor |
1 |
Power vehicle |
1 (8 to 30 V) |
SD card connector |
1 |
Operating temperature |
-20°C / +70°C (for any specific request, contact us) |
Dimensions (cm) |
12 x 8.2 x 2.6 |
SOFTWARE & FEATURES
Location Services
GPS Driver
- Signal quality: number of satellites, number of seen Satellites
- GPS management: stop, start, reset, the GPS
- AGPS (option)
- Select antenna source (internal/external)
Communication Engine (GPRS & SMS)
- Define the communication strategy : Periodic, event driven
- Define the protocol (TCP, UDP, .) the Frame format (through frame generator.)
- Define the roaming strategy (save data and no communication, reduced communication, preferred operator definition.)
RTC management
- Time control all features of the device including wake up and shut down/sleep
Power management
- Configure independently power modes of every modules - static/predictive mode.
- Define wake-up conditions (triggered by movement, signal change, timer, ..)
GPS Odometer and movement sensor
- Get in real time the last movement
- Movement start/stop
- Mileage, speed, heading
Geofencing
- Define defended zone (POI, polygon, line)
event handling generation